IDE jumber settings

 

Setting the Jumpers

• Master or Single Drive - Use this setting if the drive is the only drive on the ATA interface cable.
• Drive is Slave - Use this setting if the drive is an additional drive on the cable and the original drive is set as Master.
• Master with non-ATA compatible drive - Use this if the drive is Master to a CD-ROM, tape drive or other non-ATA drive.Note: It is preferred to have the CD-ROM and other non-hard drive products on the secondary ATA channel.
• Cable-Select Option (Default) - Use with Ultra ATA cables. This allow the cable to select if the drive is master or slave based on the position on the cable. The Master drive goes on the black connector at the end of the cable, the slave drive connects to the gray connector in the middle and the host adapter connects to the blue connector at the other end of the cable.
• Limit Capacity Option - This option may be required if the system the drive is being installing into does not support the full capacity of the drive. If the limit capacity jumper is installed you will need to use a drive overlay program such as the one installed by Disc Wizard Starter Edition.

The figure below depicts the jumper settings for the U-Series and Barracuda ATA drive families (most Seagate ATA drives above 20 GBytes). If you have an older drive please visit our Technical Library and find your model number for details on jumper configuration.